The RF401A and RF411A have distinct advantages over their predecessors, including greater maximum transmit power, lower average power consumption, improved packaging, and the inclu …
仪器使用
Hi,I have a Vaisala WXT520. In order to connect with CR10X, I am trying to program using Edlog 32 in LoggerNET with reference a manual, 'http:www.campbellsci.comdocumentsmanualswxt …
I'm investigating using PakBus over radio. I have read the PacBus net guide, but I can't find any typical "Hop Metric" figures, or any data on how many transactions are r …
The following are some suggestions:Keep the optics clean.Site-specific field calibration may be necessary for the best performance. Prevent the sensor from freezing. …
The CS616 and CS625 are the same in size, form, and function. The only difference is in the output signal. The CS616 has a ±700 mV square wave output, whereas the CS625 has …
I came across an old CR500 and when I was replacing the Lithium internal batteries of a couple other data loggers, I was surprised to find see that there was no internal battery fo …
Hello,I've done BASIC programming before, but I am new to the world of CRBasic. Any suggestions on where to start?新对话如下：Campbell Scientific conducts training classes every month.Th …
EasyFlux® DL in its native form only supports Campbell Scientific open-path gas analyzers (that is, IRGASON or EC150). In some cases it may be possible to adapt the EasyFlux&re …
I have recently started working on a project using CR510's and am concerned w problematic connection.I use the SC32B adaptor when connecting, but I learned that it has not been use …
>Can EasyFlux® DL be used with a sonic anemometer besides the IRGASON or CSAT3A? _Campbellsci 数采常见问题
EasyFlux® DL in its native form only supports the IRGASON or CSAT3A sonic anemometers. It is possible to adapt the EasyFlux® DL program to support other Campbell Scientific …