HiI am trying to measure the time it takes for a channelport to go to HIGH (+5V) on a CR215216 with in a scan.This channel is the output from be a basic ultrasonic range sensor tha …
仪器使用
EasyFlux® DL is now available for both the CR3000 and CR6 dataloggers. …
In most cases it is possible to adapt the EasyFlux® DL program for other biomet or energy balance sensors. Contact Campbell Scientific to discuss the possibility of customizati …
Hello!I try to process an ASCII file, which includes data from a CSAT3 sonic anemometer and other instruments, with Edire software but it seems not working, not reading the data. T …
Hello everyone.I have a Campbell CR200series Weather Station sending data to the LoggerNet software, and i would like to send my data to the WUndergroung and from it to a web page. …
EasyFlux® DL samples the eddy-covariance sensors at 10 Hz. It is possible to measure at 20 Hz using EasyFlux® DL C6OP running on a CR6 datalogger. …
HiWe upgraded the OS in a CR10X to the ModBus enabled version and it runs fine when using the CS-IO port. Unfortunately this port is actually not available as it is used to upload …
EasyFlux® DL has been tested in a variety of landscapes including forest, open water, short crops, and desert. It has been found to work well in all landscapes, assuming the in …
To set up EasyFlux® DL, follow these steps:Open EasyFlux® DL in a text editor, such as the CRBasic Editor.Set the instrument constants (for example, which sensors are being …
Hi all,we recognized a strange behavior in Loggernet and can not find the problem! Maybe someone can help? We have two measurements. Both are running a CR1000 to store 1hz data on …