Yes, as do all radios. Adjacent radio equipment operating in the same frequency range can cause interference. …
仪器使用
I'm having problems with the latest versions of RTMC and RTMC Web Server, I cannot access the server I.P. addressdata from remote locations.Using my laptop at the location of the s …
The RF401A can be powered either from a 12 Vdc source via the field power cable, or from a data logger via the CS IO port. …
I am using the CR800 and an SDI-12 v. 1.2 compliant sensor.In the help file for the SDI-12Recorder function it says, "If the sensor response time is greater than the scan time …
>Is there a limit to the length of antenna cable that can be used with an RF401A?_Campbellsci 数采常见问题
Yes. All antenna cables introduce a loss in the effective output of the system. The longer the antenna cable, the greater the loss. …
Hi,the data sheet of the CR1000 states (for analog inputs, at temp. = -25°C to 50°C): Accuracy: +- (0.12% of reading + offset) So there is a max. possible absolute error ("off …
Hello everybody,I need to install 48 PT100 (2-wire) on a Campbell datalogger with a 1632 MultiplexerThese sensors where already used on a datalogger, connected with halfbridge like …
Dear Sir:How can I output ten minutes moving average every one minute? I use cr-1000, but when I config a ten minutes moving average item, it always output every ten minutes. Can I …
Some settings are available remotely through the PakBus Graph tool, but only if the RF401A has previously been configured to act as a PakBus Node. …