There is no heater along the intake pipe of the CPEC200. An air gap insulates the intake pipe (18 in. OD) from the outer shell (12 in.ID), so the air traveling down the i …
仪器使用
BAsed on suggestions from a previous forum discussion I am trying to change my NL100 to PAKBUS from TCPser.The system uses loggernet 3.4 to connect via Ethernet to the NL100, from …
The pump module fan continues to draw 0.7 W while operational. …
I am trying to put together a fairly simple HMI for calibrating turbine flow meters and potentially pressure cells. I was wondering if you can use the setpoint box in RTMC to chang …
Yes, the pump works a little harder with the new vortex. The recommended flow for the new vortex system is 8 LPM (6 to sample cell + 2 to bypass). 7 LPM was recommended for th …
Anyone used the CS475 or 476 for measuring snow depth?Any idea about how the measurements compare to SR50 or SR50A?what levels of accuracy are achieved for snow measurements?Anyone …
Yes, the heater is controlled the same way. Campbell Scientific recommends leaving the heater on all the time. …
question 1: CR9000 9051 can be mounted a few pieces of PT100 4-wire thermometer?question 2: CR9000 AI input is not enough, CR9000 can be installed two 9051? …
The NL200-series of devices can be set to bridge the Ethernet or Wi-Fi interface and the CS IO interface. All packets that come into the device via Ethernet or Wi-Fi will be transf …
Hi everyone,during the course of a research project I have developed a PakBus API in Python. The project is called PyPak. We use it mainly to transfer data from CR 1000 data logger …