The SDI-12 bus is capable of having at least 10 sensors connected to it, each with 200 feet of cable. With fewer sensors, longer cable lengths are possible. …
仪器使用
Hi,I'm using a CR1000 with an NL115 compact flash module, and a 2 Gb CF card. Data is output to the card using the commandCardOut(0, -1)When I collect data, I copy the raw data fil …
For maximum accuracy, Campbell Scientific generally recommends that all sensors be recalibrated every two years. Depending on the requirements of the application, it may be de …
Compare the sensor against a recently calibrated CS320 on a clear, sunny day with the sun overhead. Ensure that the sensor being used as a reference is also level. …
I have been programming CR500, CR510, CR10X and CR10 loggers with the INW pressure transducers (PS9104E, PS9105 and PS9805).To program this equipment I have been using Shortcut Sof …
Just wondering if anybody is using this sensor with a CR10X logger? If so was wondering if you could supply programming instructions.Thanks新对话如下：PNBOR,I'm hoping someone else jumps …
The leveling base provides physical stability and helps ensure the sensor is leveled correctly. It is not recommended to use the sensor without the base. The sensor mounts to the b …
Is there any way to set the defaults in the email setup popup window for Alarm components in RTMC Pro?Or is it necessary to enter this information in for each alarm.I know I can se …
No. It’s not the range that makes a sensor a quantum sensor. It is the type of light filter used with the photocell that only allows specific wavelengths of light in the PAR …