To connect a data logger to an OMNISAT-M, use the RS-232 port of the data logger. Connection using the CS IO port of the data logger will not be successful. …
仪器使用
I'm using Short Cut 2.8 and was curious if you can use "time" as a variable to actuate a device using the Simple Control wdeadband option? It does not appear in the drop …
The SDM8X50 is the same as the SDMX50SP in form, fit, and function. When purchased with the –E enclosure option, a 10 x 12 in. environmental enclosure is included, making it …
I am developing a set of Microsoft Visio wiring diagrams for Campbell Scientific-based installations. These diagrams would benefit greatly from a library of vector-based graphic im …
The hermetically sealed relays used in the SDM8X50 are much quieter than the relays used with the retired SDMX50-series multiplexers. Although listening for the clicking on the SDM …
Per our customer's request, we are trying to setup multiple NL100s and CR100s in a fashion similar to a standard MD485 network:Computer <<<>>> NL100 #1 RS-232 Por …
The maximum recommended segment length (length of cable between the NL device and the Ethernet repeater, hub, switch, or router it is connected to) for 10Base-T and 100Base-Tx …
Hi all,I am having a problem with the PulsePort command (long winded post ahead)I use C4 and C7 to control two servo motors using pulse width modulation.Originally I used the PWM c …
Yes. The communications tasks run independently of each other, and multiple computers can be connected at the same time. If PakBus is being used to communicate, ensure that the com …
As I understand sending a "M!" command with "SDI12Recorder" will send a "D0!" after the sensor response time expires.Is it possible instead to send a …