Using a CR1000 and CRBasic, if you have an initial scan rate of one second Scan(1,sec,3,0) and then have a sub routine with the same scan rate do they run concurrently in parallel …
仪器使用
MetSENS has a compass module that outputs at 1 Hz real time without affecting any other measurements, which allows the correction of wind direction if the station is installed on m …
I'm trying to send a new program to a CR206 via GPRS modem and I get this error when I try to send the program: CR2compv07.exe. I have restarted LoggerNet (as it sometimes hangs up …
I need to interface the CR1000 datalogger with the TC65 GPRS terminal. All the recorded statistics like temperature and humidity should be sent through that terminal to an FTP serv …
Two files from a CR3000 appear to be damaged; at least that was the message shown on logger net when using Card convert ("Input file contained no data. If the file should have …
Using Short Cut, click the applicable wind direction sensor in the Selected Sensors list of the Outputs screen.The two output options enabled are Sample and WindVector. Select Wind …
It is possible, but Campbell Scientific does not recommend user replacement. Factory replacement is strongly recommended. …
I'm currently using CR23X to measure two temperature and a voltage,the program in PC200W 4.0 in Win 7. It runs well and I was able to see the data changing, but when I go to collec …
Hi,I'm trying to update my RTMC version to 3.1, that is available at http:www.campbellsci.com2_1483_14_1.I have Loggernet 3.4 and RTMC 2.4 (development and run-time) installed.When …