The CR6 has true RS-232 levels on the RJ45 (CPI), and the data logger can be programmed for RS-232 levels on C1-C2 and C3-C4. …
仪器使用
Hello,In a certificate of calibration of the datalogger CR1000: - Does tolerance in mV correspond with the expanded uncertainty, with k=2?. -Which is the tolerance in mV to values …
R. M. Young, the manufacturer of this sensor, recommends a maximum cable length of 300 m (984.25 ft) between the wind monitor and a data systemdisplay. For longer cable runs, …
Hello, I am using up a bunch of our CR1000 control ports reading wetdry contacts and I'm running out.I looked at expanding the control ports with a SDM-CDXX module but budgets kill …
The CS110 uses the same gas discharge tubes, etc., so it provides similar surge protection as the CR1000. The ground paths are different, although both are intended to provide a go …
helloI've read the features of powerup.ini in the CR800 and CR1000 manuals. Though I'm not sure which hardware it needs to benefit from powerup.ini.Does it work only on a CF card? …
Two CS547A-L probes can be wired to a CR1000 datalogger, and three CS547A-L probes can be wired to a CR3000 datalogger. To wire additional probes to either of these data loggers, a …
Is it possible to upload a new OS to a CR1000 without a direct serial connection? In my case, I'm communicating with the datalogger using LoggerNet over TCPIP. The datalogger has a …
Cloud heightCloud height is commonly used to refer to the height of the cloud base above ground level. (This is what the ceilometer reports.) However, it can also be used to refer …
helloI like to use my own constant to open a port for serial comminications. First I tried to use a string constant, but the compiler requested a numeric constant.Based on the list …