Is it possible to configure the FTPClient command to send more than one file at a time? In other words, can I give it an array of file names to transmit? If so, how would I structu …
仪器使用
No. The SI-111SSCBL is used with the SI-111SS. …
Hi, Perhaps I missed it but I didn't see this mentioned in the manual for the CFM100 but if you wish to save the same data elements to both the CR1000 memory and the storage module …
As a general recommendation, recalibration should be done every two years. …
Hello,I am trying to hook up a PT100 to the Campbell C1000 datalogger. I know the wire's resistance and prefer to do a 2-wire measurement on the resistance, correcting afterward fo …
The window in the Apogee infrared sensor is inset and protected, but it can become partially blocked in three ways:Spiders can make a nest in the entrance. Campbell Scientific reco …
Everyone,I have a Cr1000 that is working 100%, but two days ago it stopped logging any data. Any help ?SincerelyJames新对话如下：Hi James,Could be any number of reasons, can you give mor …
There are two accuracy specifications listed for the SI-111SS:One for when the difference in the target and sensor body temperatures is less than 20°C (more accurate)One for wh …
Hello Everyone,I'm looking for some guidance with shaft encoders, specifically this one http:www.quantumdev.comproductsoptical_encodersqd145.htmlWe are using the device in the TTL …
The SI-111SS can be used to measure a wide variety of surfaces, including water and snow. When measuring objects with low emissivity, however, it is particularly important to apply …