Reach Robotics Pty Ltd and UNSW’s Australian Centre for Space Engineering Research (ACSER) have signed a Memorandum of Understanding (MoU) to reflect plans to collaborate on enviro …
文档资料
Last week, the 2022 Maritime RobotX Competition took place at the Sydney International Regatta Centre in Penrith. RobotX is an international competition designed to build universit …
Per our customer's request, we are trying to setup multiple NL100s and CR100s in a fashion similar to a standard MD485 network:Computer <<<>>> NL100 #1 RS-232 Por …
The maximum recommended segment length (length of cable between the NL device and the Ethernet repeater, hub, switch, or router it is connected to) for 10Base-T and 100Base-Tx …
Hi all,I am having a problem with the PulsePort command (long winded post ahead)I use C4 and C7 to control two servo motors using pulse width modulation.Originally I used the PWM c …
Yes. The communications tasks run independently of each other, and multiple computers can be connected at the same time. If PakBus is being used to communicate, ensure that the com …
As I understand sending a "M!" command with "SDI12Recorder" will send a "D0!" after the sensor response time expires.Is it possible instead to send a …
The CR6 has true RS-232 levels on the RJ45 (CPI), and the data logger can be programmed for RS-232 levels on C1-C2 and C3-C4. …
Hello,In a certificate of calibration of the datalogger CR1000: - Does tolerance in mV correspond with the expanded uncertainty, with k=2?. -Which is the tolerance in mV to values …
R. M. Young, the manufacturer of this sensor, recommends a maximum cable length of 300 m (984.25 ft) between the wind monitor and a data systemdisplay. For longer cable runs, …