Dear Sir
I have E20 Pyranometer sensor,and want to measeur with CR1000,but I have CS300 user manual.
Please tell me command of CS300 read E20 sensor?
Best Regards
Alex,
You can use either instruction; VoltDiff or VoltSE. If it's an older sensor you will want to make sure its been calibrated for more accurate measurements.
Regards
* Last updated by: sonoautomated on 11/3/2010 @ 7:56 AM *
Alex,
I have done a few projects about Pyranometers,
Please send me E20's catalog and CS300 's user manual,
I will help you to programming it.
BRs,
Nguyen Van Hung
--------------------------------------------
Measurement and Control Equipment Co., Ltd
This is my mail:
nvhung.mctt@gmail.com
I also have CR1000 data logger and E20 pyranometer jauntering.
E20 Jauntering only have two cable output.
sensitivity : 48uV/W/m^2
Linierity : max deviation of 1% up to 3000 W/m^2
Accuracy : 3%
spectral range : 400 - 1100 nm
response time : typical 2uS
could you help me to configure the CRbasic
Tq
Ariffudin
