The maximum recommended segment length (length of cable between the NL device and the Ethernet repeater, hub, switch, or router it is connected to) for 10Base-T and 100Base-Tx …
最新内容
Hi all,I am having a problem with the PulsePort command (long winded post ahead)I use C4 and C7 to control two servo motors using pulse width modulation.Originally I used the PWM c …
Yes. The communications tasks run independently of each other, and multiple computers can be connected at the same time. If PakBus is being used to communicate, ensure that the com …
As I understand sending a "M!" command with "SDI12Recorder" will send a "D0!" after the sensor response time expires.Is it possible instead to send a …
The CR6 has true RS-232 levels on the RJ45 (CPI), and the data logger can be programmed for RS-232 levels on C1-C2 and C3-C4. …
Hello,In a certificate of calibration of the datalogger CR1000: - Does tolerance in mV correspond with the expanded uncertainty, with k=2?. -Which is the tolerance in mV to values …
R. M. Young, the manufacturer of this sensor, recommends a maximum cable length of 300 m (984.25 ft) between the wind monitor and a data systemdisplay. For longer cable runs, …
VO200多普勒超声波流量计基于多普勒超声波测速采用DSP技术和先进的频谱分析算法专为水体流速、流量测量设计。它没有旋浆、轴承等转动部件用多普勒技术探测流速无摩擦、无惯性测量点在机体前方不破坏流场具有测量精度高、量程宽感应灵敏测流线性不惧泥沙、漂浮杂物读数直观操作简便不易损坏等特点。VO200多普勒超声波流量计技术参数：速度测量范围：0.02-5ms精度：1 …
Hello, I am using up a bunch of our CR1000 control ports reading wetdry contacts and I'm running out.I looked at expanding the control ports with a SDM-CDXX module but budgets kill …
The CS110 uses the same gas discharge tubes, etc., so it provides similar surge protection as the CR1000. The ground paths are different, although both are intended to provide a go …